WALBRO WT-668 BALL-BEARED

This Walbro WT-668 is a regular carburettor which may be fitted without problems on any type of motor. In this carburetor are both needles, (low and high), separated from each other so that they do not affect each other so much.

The Throtle valve is on both sides provided with a ball bearing with rubber seals, so that there is absolutely no wear and leakage can occur, and therefore no dirt can get into the motor. In addition, the negative pressure-upper pressure pop-off has been checked so that the carburettor lets the fuel through at the right time.

Default settings:

• Stationary screw: 2 turns
• Lower mixing screw (L) one and a quarter turn open
• Upper mixing screw (H) one and a quarter turn open

Specifications:

• Bore: 12,7 mm
• Venturi: 18,6 mm

Suitable for all engines in our program and similar types.

NOTE! This carburetor comes without the gas lever!