Futaba Magnetic RPM ​​sensor set SBS/01RM

The Futaba SBS-01RM magnetic RPM sensor makes it easy to read RPM on the transmitter. Simply connect the sensor to the S.BUS2 port of the telemetry-compatible receiver, and the bi-directional communication ensures that the data is sent directly to your Futaba T-FHSS or FASST transmitter.

Magnets mounting:

• Mount the first magnet with the active side to the sensor at the desired location of the rotating part, this can be done by gluing with 2-component glue or epoxy. The second magnet should be mounted in the opposite position to ensure balance. Make sure that the magnet with the non-active side points in the direction of the sensor, since the measurement will then be incorrect. This is easy to check in the manner described below.

Sensor mounting:

• The sensor must be mounted in a stable place, with or without the supplied holder. The distance between the magnet and sensor may be a maximum of 2 mm. After this mounting, connect the sensor to the module, and the module to an S.BUS2 port on the receiver.

Check sensor operation:

• When voltage is applied to the Sensor, the LED is on, no sensor signals are sent.
• The sensor only works when the active-side of the magnet is facing the sensor. You can check this by moving the magnet past the sensor.
• If the LED is blinking, this is the active side. Mark the active magnet side with a marker so that the assembly goes smoothly later.

Specifications:

• Displays: RPM/revolutions per minute
• Range: 360~100,000 RPM
• Cable length: 255 mm
• Voltage: 3.7~7.4 Volt
• Weight (with pick-up): 4.7 grams

Important:

• The SBS-01RM can only be used with telemetry receivers that have S.BUS 2 port(s). Refer to the manual supplied with your transmitter and/or receiver.