LOSI steel drive axle center-rear LOS252021.

Commbined with connection to the output shaft of the front differential housing. The length of the shaft is measured from pin to hinge pin, suitable for the LOSI DBXL

Dimensions:

• Length: 140 mm

Drive shaft pins removal and assembly:

Required tools:

• Sturdy bench screw
• Hammer
• Steel pin
• Good quality Hex pins (TPS0280)

Methode:

• Remove the Allen screws
• Open the vice until the pin just fits between the jaws
• Lay the shaft flat on the vice with the pin in the small opening
• Knock the entire pen out of the ashes with policy
• Take the new pin and lubricate it with TPS648/10 bushing-and-bearing
• Knock the new pin in the ball untill both end are equal long
• Re-tighten the Allen screws with the TPS271/10 screw lock