ZN0056 Zenoah Pull starter rope, 1 pc.
In stock
Order now and it will be sent tomorrow 31 January 2025
Original Zenoah recoil starter cord ZN0056
Suitable for:
- Zenoah G230
- Zenoah G240
- Zenoah G260
- Zenoah G270
- Zenoah G290
- Zenoah G320
- Chung Yang
- Dynamic
- HPI Feulie
- BWS Feulie
- King Motors
- BWS/30N
- Similar engines
Replace recoil starter cord:
- Remove recoil starter from engine
- Pull recoil starter rope out a bit, and hold the spring cassette on the inside
- Now turn the spring cassette so that its notch is released, and place the cord in it (Photo 1)
- Now let the spring cassette gradually turn back until there is no more tension on it
- Now loosen the middle screw, and remove the carrier parts (Photo 2)
- Now remove the white cassette with rope carefully so that the spring remains in the black housing
- Look carefully at how the old rope is in the holder, and replace it with the new one
- Now put the spring cassette back, PLEASE NOTE that the hook of the spring falls into the cam of the pull starter housing! (Photo 5)
- Now mount the driver parts in the order: 1) driver, 2) spring, 3) driver disk, 4) ring and 5) screw, use Loctite 271 for the last one
- PLEASE NOTE that the ring with the square hole falls over the cam of the pull starter housing!
- Reassemble the drive parts in the correct order and spray it with 3-IN-ONE® Lock Dry Lube
- Turn the spring cassette until the notch of the retractor mechanism is free, and place the cord in there (Photo 6)
- Now turn the whole thing 5 to 6 times 360 degrees counterclockwise so that the spring is tensioned again and the pull starter handle comes back. (Photo 7)
Validate your login
Sign In
Create an Account