Radiolink R7FG Version 1.4 2.4 Gig Receiver

For those who are not familiar with Radiolink, they have been bringing innovative, high-quality and very competitively priced RC products to the market since 2013.

This 7 channel 2.4 Gig. water resistant receiver is one of the last receivers available for the RC8X steering wheel transmitter. This has a built-in Gyro and telemetry. These can be fully read and set via the RC8X transmitter. Thanks to the optional sensors, other functions can also be viewed through the S-BUS port.

Further features:

• The R7FG has built-in telemetry, which means that you can read the voltage of the receiver battery on the transmitter. With electric models you can also read the voltage up to 6S Lipo of the drive batteries through the supplied sensor cable. This connects to the available telemetry port. Other telemetry functions can be accessed with additional sensors via the S-BUS port.
• Channel 1 to 6 are with PWM signal output, channel 7 is with PPM or SBUS signal output. The signal output mode can be set so that, for example, a boat or car with FPV is supported.
• The integrated high-performance gyro uses the software filter and PID algorithm. Corrects sensitivity in a timely and accurate manner and improves stability. The good flexibility for different models easily achieves professional performance even with drift cars.
• This receiver can be used in three different modus: Car mode: Forward, backward and brake, Racing mode: Forward and brake, no backward, Boat and Tank mode: Forward and backward, (brake can be turned off and on).
• This R7FG is protected against incorrect connection so that it cannot be damaged.

Data R7FG:

• Frequency: 2.4 Gig.
• FHSS 67 channel hopping
• Version: V1.4
• Number of channels: 7
• Built-in Gyro
• Voltage: 3~12 volts
• Power consumption: 30 mAh
• Dimensions: L35-B22-H13.5mm
• Weight 7 grams
• Antenna length: 20.5 cm
• Signal Out: S-Bus-PPM-PWM
• Range: ± 600 mtr.
• Compatible with: Radio Link RC8X, RX8X RC6GS V3, RC4GS V3, RC6GS V2, RC4GS V2